Practise › Questions › Capacitors and energy stored
Capacitors and energy stored questions
A capacitor is two plates and a gap, rated by how much charge each volt of pd parks on them. Fill the gap with the right material and the rating climbs; charge it up and the energy it holds is a triangle on a graph, growing as the square of the voltage.
19 original questions · 56 marks · the capacitors and energy stored notes · Capacitance
Every question here is written for this library rather than taken from a past paper. Write your answer out before opening a mark scheme: the schemes award marks point by point, and the marks are easier to see when you have something of your own to compare against.
Define capacitance and state its unit.
Mark scheme
Charge stored per unit potential difference, C = Q/V (1); unit: farad (F), equal to one coulomb per volt (1).A capacitor stores a charge of 6.0 × 10−3 C when the potential difference across it is 12 V. Calculate its capacitance.
Mark scheme
C = Q/V = (6.0 × 10−3)/12 (1)
C = 5.0 × 10−4 F (500 μF) (1)Write down three equivalent expressions for the energy stored by a charged capacitor.
Mark scheme
E = ½QV (1); E = ½CV2 (1); E = ½Q2/C (1).A capacitor is charged in stages and a graph of charge stored against potential difference is plotted. State what is represented by the gradient of this graph.
Mark scheme
The capacitance of the capacitor, since the gradient is Q/V = C (1).The capacitor in a defibrillator stores a charge of 0.36 C when charged to a potential difference of 1.8 kV. Calculate its capacitance.
Mark scheme
C = Q/V = 0.36/1800 (1)
C = 2.0 × 10−4 F (200 μF) (1)A 50 μF capacitor is used in a signal filter. Calculate the potential difference needed for it to store a charge of 4.0 mC.
Mark scheme
V = Q/C = (4.0 × 10−3)/(50 × 10−6) (1)
V = 80 V (1)A 100 μF capacitor is charged to a potential difference of 20 V. Calculate the charge stored and the energy stored.
Mark scheme
Q = CV = 100 × 10−6 × 20 = 2.0 × 10−3 C (1)
E = ½CV2 = ½ × 100 × 10−6 × 202 (1)
E = 0.020 J (1)A capacitor stores a charge of 5.0 × 10−3 C at a potential difference of 8.0 V. Calculate the energy stored.
Mark scheme
E = ½QV = ½ × 5.0 × 10−3 × 8.0 (1)
E = 0.020 J (1)A parallel-plate capacitor has plates of area 0.020 m2 separated by a 1.0 mm vacuum gap. Calculate its capacitance.
ε0 = 8.85 × 10−12 F m−1A 470 μF capacitor in a camera flash unit is charged to 9.0 V. Calculate the charge stored and the energy stored.
The sensing pad of a touch screen behaves as a parallel-plate capacitor. The pad has an area of 4.0 cm2 and the plates are separated by a 0.10 mm layer of glass with relative permittivity 5.0. Calculate the capacitance of the pad.
ε0 = 8.85 × 10−12 F m−1A student charges a capacitor from a variable supply and plots the potential difference across it against the charge stored. The graph is a straight line through the origin that passes through Q = 3.6 mC at V = 12 V. Determine the capacitance of the capacitor, and use the graph to determine the energy stored at 12 V.
A 1500 μF capacitor in a bicycle rear light is charged to 6.0 V. Show that the energy stored is about 27 mJ. Go on to calculate the average power delivered when the capacitor discharges completely through the LED in 0.30 s.
The capacitor in the earlier question (177 pF with a vacuum gap) has the gap filled with a dielectric of relative permittivity 4.0. Calculate the new capacitance and state the effect on the energy stored if the capacitor remains connected to the same supply voltage.
A 220 μF capacitor stores a charge of 3.3 × 10−3 C. Calculate the energy stored and the potential difference across the capacitor.
Explain how inserting a polar dielectric between the plates of a capacitor increases its capacitance.
A designer needs a capacitor for a memory back-up circuit. It must store at least 2.5 J when charged to its maximum rated potential difference. Two capacitors are available:
capacitor P: capacitance 0.10 F, maximum rated pd 6.3 V
capacitor Q: capacitance 0.022 F, maximum rated pd 16 V
Deduce which capacitor, if either, meets the requirement.A parallel-plate capacitor containing a polymer dielectric sheet of relative permittivity 2.5 is charged and then disconnected from the supply. The sheet is then withdrawn from between the plates. State and explain what happens to the capacitance, the charge stored, the potential difference across the plates and the energy stored.
A camera flash unit uses a capacitor, charged by a small battery, to supply a xenon flash tube. Explain why the energy stored by the charged capacitor is ½QV rather than QV, and explain why a capacitor, rather than the battery alone, is used to supply the flash tube.
The same practice on paper: the printable workbook for this topic, questions and a worked answer book.
Practise capacitors and energy stored one question at a time
The player marks nothing for you. It shows one question, waits, then shows the scheme so you can mark yourself, and brings a question back sooner when it went badly.